Foot Pocket Fin Rail
Rubber fin rail for installing fin blades in foot pockets. Sold by the foot
The foot pocket rubber fin rail is designed for optimal fit and grip. For use with foot pockets that have a T slot inside the tendons to secure them to the blade such as OMER, H Dessault, Picasso, Riffe, Spetton etc. The grade of rubber was chosen for the correct balance between stiffness and flexibility, allowing the rail to flex with the blade, and the rail lip to be rigid to keep the foot pocket tendons from slipping off. These rails can be installed on any fiberglass or carbon blades. Read more about different kinds of rails, and what makes some better than others Fin rails explanation.
Old worn out rails can be scraped off using a utility knife or a stiff razor. Do not be overly concerned about damaging the fiber blades, just confine the scraping to the area that the rubber rails will cover. Cutting a little into the resin of the fiberglass or carbon blades will not cause a problem. Before gluing on the rails the surface of the blade should be free of old rubber and glue residue, a final cleaning with an Acetone soaked rag will insure a good bond. Cyanoacrylate glue such as krazy glue is used to permanently bond the new rails to the blade. For best results use a Q-tip dipped in acetone to clean the groove of the rail where the blade will fit.
2ft are usually enough to do one blade, but measure your old rails to be sure. Rails are easily cut to correct length with scissors.